Skip to content

Valves & Flow Control Products

Control Valves

Pneumatic diaphragm and piston-actuated control valves, electric actuated valves and self-operated regulators, with linear or equal-percentage trim. These are the valves that modulate rather than isolate, and their sizing depends on the process conditions rather than on the pipe size.

A control valve sized from line size alone will usually be oversized, which forces it to run near closed, where it is noisy and unstable. The information a factory needs is flow rate, upstream and downstream pressure, fluid and temperature, and the required rangeability — the same data a process engineer would use for a sizing calculation.

Regulating valves with pneumatic actuators.

Other types in this category

  • 15 product familiesone purchase order
  • Exported from NingboEXW / FOB / CIF / DDP
  • One specification sheetquoted line by line
  • Reply in 1 business dayfrom a named person
Start your sourcing project →

Specification

What to write down before you ask for an offer

Control Valves has its own set of fields — these are the ones that decide whether a quotation is comparable.

Send these details
  1. 01

    Flow and pressure drop

    Minimum, normal and maximum flow, with the pressure drop at each condition.

  2. 02

    Fluid data

    Liquid, gas or steam, with density, viscosity and temperature.

  3. 03

    Trim characteristic

    Linear, equal percentage or quick opening, matched to the process.

  4. 04

    Actuator

    Spring-to-open or spring-to-close, air supply pressure, and fail-safe position.

  5. 05

    Positioner and signal

    4-20mA, HART or digital, and whether a positioner is included.

  6. 06

    Noise and cavitation

    Whether the duty requires anti-cavitation or low-noise trim.

Common questions

Control Valves — asked often

For the wider category context, see Valves & Flow Control Products.

Can you size a control valve for us?

We can pass your process data to the factory and have them run the sizing, and we will show you the assumptions they used. The engineering approval should still sit with you or your process engineer, because the sizing depends on conditions we cannot verify. We are a supplier, not the designer of your process.

What does fail-safe mean for a control valve?

It defines what the valve does when the air supply or signal is lost: spring-to-close, spring-to-open, or hold position. The choice is a safety decision about the process, not a purchasing preference. It has to be stated on the order because the actuator spring and the yoke are built for one configuration only.

Control Valves to a written specification, delivered

Send the size, material or rating you need, plus a quantity. If you have an existing part number or a supplier quotation to compare against, include it — that is usually the fastest way to a usable answer.

We reply within 1 business day — from a named person, not an auto-responder. Your requirement is confirmed first; the quotation follows once details are agreed.