Skip to content

Hydraulic & Pneumatic Components

Hydraulic Pumps & Motors

Gear, vane and piston pumps and motors, in the mounting patterns that dominate industrial hydraulics: SAE two-bolt, ISO four-bolt and CETOP. Gear pumps cover the low-to-medium pressure range and are the most widely produced in China; piston units cover higher pressure and better volumetric efficiency, with tighter tolerances and better contamination resistance.

The purchase decision is usually not "which type" but "which unit replaces the one that failed without changing the circuit". Displacement, mounting flange, shaft type, port position and rotation direction are the five fields that decide that, and rotation direction is the one most often omitted from an inquiry.

Gear, vane and piston units in standard mountings.

Other types in this category

  • 15 product familiesone purchase order
  • Exported from NingboEXW / FOB / CIF / DDP
  • One specification sheetquoted line by line
  • Reply in 1 business dayfrom a named person
Start your sourcing project →

Specification

What to write down before you ask for an offer

Hydraulic Pumps & Motors has its own set of fields — these are the ones that decide whether a quotation is comparable.

Send these details
  1. 01

    Displacement

    cm³/rev at the required speed, and whether the duty is pump or motor.

  2. 02

    Mounting flange

    SAE A/B/C two-bolt, ISO four-bolt, or a flange drawing with pilot diameter.

  3. 03

    Shaft

    Straight keyed, splined or tapered, with the exact shaft diameter and key size.

  4. 04

    Ports and position

    Thread standard, size, and whether the ports must face a particular direction in the installation.

  5. 05

    Rotation

    Clockwise or counter-clockwise viewed from the shaft. Not reversible on most gear pumps.

Common questions

Hydraulic Pumps & Motors — asked often

For the wider category context, see Hydraulic & Pneumatic Components.

Can a gear pump be run as a motor?

Many gear units are bidirectional and are sold for both duties, but the bearing and drain arrangement differs. If the unit will be driven as a motor, say so in the inquiry — a pump-pattern unit used as a motor can fail at the shaft seal because the drain path is wrong for that direction of flow.

What pressure should I specify?

Continuous working pressure and peak pressure as two separate figures, plus how long the peak lasts. A factory rating of 250 bar is often a peak figure; continuous rating may be 200 bar or lower. Quoting a pump at its peak rating for continuous duty is one of the common causes of short service life.

Hydraulic Pumps & Motors to a written specification, delivered

Send the size, material or rating you need, plus a quantity. If you have an existing part number or a supplier quotation to compare against, include it — that is usually the fastest way to a usable answer.

We reply within 1 business day — from a named person, not an auto-responder. Your requirement is confirmed first; the quotation follows once details are agreed.